Guangdong Uchi Electronics Co.,Ltd
Guangdong Uchi Electronics Co.,Ltd Manufactuer of Varistor, Thermistor, Capacitor,Fuse & Resistor since 2006 !
Add to Cart
No Center Pin With Cover 5x20mm Ceramic Fuse Holder Block PTF-76 10A 250V UL With Terminal Pitch 15mm
Suitable Fuse
5x20mm Time-Lag / Fast-Acting glass fuse SFC series,STC series,FBC Series,TBC Series
5x20mm Slow blow / Fast Blow Ceramic Tube Fuse BFC Series, BTC Series
Betterfuse glass tube fuse 531 sereis,582 series,573 seris,571 series,523 series
Betterfuse Ceramic Fuse 527 series,522 series,521 series,512 series,511 series
Lansonfuse 5D,5E,5G,5H,5J,5K,5M,5N,5P,5Q,
PTF-76 Specifications
| Color: | Green |
| Current Rating (A): | 10 A |
| Dimensions (H x W x D): | 11.5x9.4x24.4 mm (0.453x0.370x0.961") |
| Fuse Type: | 5x20mm glass fuse |
| Mount: | Horizontal Open |
| Operating Temperature: | -30° - +85°C |
| Spacing: | 15 mm (0.591") |
| Voltage (V): | 250 V |
Features
PTF-76 5X20mm PCB Fuse Holder, Horizontal Mount, 15mm Pin to Pin Spacing, No Center Tab, 10 Amp, 250 Volt, UL
PTF-76 5 X 20 mm PCB Mount Fuse Holder, 15 mm Pin to Pin Spacing with no center tab. It is rated at 10 amp at 250 volt.
• clip fuse holder consisting of a soldered-holder with insulated brass springs
• for glass tube micro fuses 5x20mm
• made of polyamide-68, self-extinguishing (UL94V-0)
• cover is included
• metal parts made from brass with nickel layer, tin-plated
• operating voltage, max.: 250V AC
• rated current: 10A
• contact resistance, max.: 5mΩ
• insulation resistance, min.: 102MΩ
• dielectric strength: >3000V AC/60s
• PCB mounting hole: Ø 1.5mm
• colour: green
Curve
Dimensional drawing (mm)
How to Wire a Fuse Holder
Fuses protect electrical devices by providing a breaking point that will interrupt the flow of electricity in a circuit when an excess current develops. This current generates excess heat, and the range of heat tolerance depends on the components and the size of the conductor--wire--used in the circuit. Electronic devices not equipped with fused circuit protection can have an external fuse holder wired into the circuit. The do-it-yourself person can install a fuse holder in 15 minutes with a few tools and a new fuse holder.
Disconnect the electrical power source to the device.
Cut the positive--or "hot"--wire as near to the power source as possible using the wire cutting pliers.
Strip 1/4-inch off each end of the separated wires with the wire stripping pliers.
Strip 1/4-inch off each of the wires on the ends of the fuse holder. Be sure to hold each wire firm when stripping to avoid stress on the fuse holder’s internal connections.
Twist the end of the wire from the power source in either direction creating a helical, or spiral, form. This helps to make the stripped ends firm for connecting.
Insert the twisted wire from the power source into one end of the butt-splice crimp connector and crimp tightly with the crimping pliers.
Insert the twisted wire from the power source into one end of the butt-splice crimp connector and crimp tightly with the crimping pliers.